400-101 Dumps-The Complete Beginner's Guide to 400-101 Exam

The Cisco CCIE Routing and Switching written exam validate that professionals have the expertise to: configure, validate, and troubleshoot complex enterprise network infrastructure; understand how infrastructure components interoperate; and translate functional requirements into specific device configurations.

For More Details:

https://www.certswarrior.com/exam/300-208/

Question: 1

Which two statements about 802.10 tunneling are true? (Choose two.)

A. It requires a system MTU of at least 1504 bytes.

B. The default configuration sends Cisco Discovery Protocol, STP: and VTP information.

C. Traffic that traverses the tunnel is encrypted.

D. It is supported on private VLAN ports.

E. MAC-based QoS and UDLD are supported on tunnel ports.

F. Its maximum allowable system MTU is 1546 bytes.

Answer: A, E

Question: 2

Which protocol allows connections made by an NBMA network to dynamically learn connected address?

A.PPP

8. NHRP

C. HDLC

D. POP

Answer: B

Question: 3

When you deploy DMVPN, what is the purpose of the command crypto is a kmp key ciscotest address 0.0.0.0 0.0.0.0?

A. It is configured on hub and spoke router to establish peering

B. It is configured on hub to set the pre-shared key for the spoke routers

C. It is configured on the spokes to indicate the hub router

D. It is configured on the Internet PE routers to allow traffic to traverse the ISP core

Answer: B

Question: 4

Which way to influence path selection with EIGRP is preferred?

A. changing the bandwidth, because it does not have any impact on other router features.

B. changing the bandwidth, because that is what Cisco recommends.

C. changing the bandwidth, because ii must be done only on one interface along the path.

D. changing the delay, even if it must be done on multiple interfaces

Answer: D

Question: 5

In which 802.1D port state are the root bridge. the root port, and the designated port(s) elected?

A. Listening

B. Forwarding

C. Learning

D. Disabled

E. Blocking

Answer: A

Question: 6

What are three valid HSRP states? (Choose three.)

A. listen

B. learning

C. full

D. established

E. speak

F. INIT

Answer: A, B, E

Question: 7

External EIGRP route exchange on routers R1 and R2 was failing because the routers had duplicate router IDs. You changed the eigrp router-id command on R1, but the problem persists. With additional action must you take to enable the routers to exchange routes?

A. Change the corresponding loopback address.

B. Change the router ID on R2.

C. Reset the EIGRP neighbor relationship.

D. Clear the EIGRP process.

Answer: D

Question: 8

Which two statement about the EIGRP Over the Top feature are true? (Choose two.)

A. EIGRP routers traffic between the PE devices.

B. Traffic is LISP-encapsulated on the control plan

C. The neighbor command must be configured with USP encapsulation on each CE device

D. The network statement must be configured on each PE device to connect separate EIGRP sites.

E. Traffic is LISP-encapsulated on the data plan

Answer: C, E

Question: 9

Which two statements about 1Pv6 6to4 tunnels are true? (Choose two)

A. Sites use addresses from the 2002::/16 prefix

B. Sites use addresses from link-local scope

C. They are point-to-multipoint tunnels

D. They are point-to-point tunnels

E. They rely on GRE encapsulation

Answer: C

For More Details:

https://www.certswarrior.com/exam/300-208/

Use Coupon code "20off2018" to enjoy 20% off.